The operation method of the burner of the asphalt mixing plant
Asphalt station burner equipment must be stable and prosperous, tires must be separately installed or unloaded, rain-proof, shock-proof, and heat-insulated work sheds must be set up, construction sites must be regular, and sedimentation tanks should be unearthed. Eradicate waste water from cleaning machinery. The power connection of the burner of the asphalt mixing plant must be correct. It is necessary to have a solid protection to zero (or protective grounding) and leakage protection switch. The wiring and insulation of each component must meet the requirements (operated by an electrician). It is necessary for the driver to clean, tighten, lubricate, adjust, and anticorrosive interspersed operation methods, and every time the mixer must be carefully protected and maintained. Every time you make a suggestion, you should carefully check whether the components are abnormal. Before suggesting the machine, you should check whether the clutch, brake and various protective equipment are active and reliable, the wire rope is not damaged, the track and pulley are excellent, FUS, ELAGE are balanced, and around it There are no obstacles, and when there are no problems, it can admit the test machine.
During the 2-3 minute test run, the cylinder rotates and balances. It does not work, does not violate, normal operation, no abnormal noise. After the advice of the machine, the driver must work hard to stick to his position. Do not leave the job without permission, and pay attention to mechanical operations at all times. Assuming an abnormal phenomenon is discovered or abnormal noise is heard, the data in the cylinder must be released and closed for repair. When the hopper is raised, it is forbidden to work or pass under the hopper. The foundation pit of the hopper needs to clean up the drought. It is necessary to contact the driver beforehand. When the mixer is overhauled, it is necessary to block the power supply. Assuming that it is necessary to enter the oil tank, it is necessary for someone to work in the electronic lock box, to prevent the use of signs, and to install special protective equipment to ensure that accidents of sending power are avoided. After production is stopped, the pipes should be cleaned up in time to avoid concrete sticking. After the operation is over, the hopper is raised to the top position, hooked up, and before leaving the scene, pull down the electric lock and lock the electric lock. Asphalt mixing station burners and station burners are driven by mixing arms, and the mixing blades drive the materials in the tank. The mixing efficiency is high, the residual amount is small, and the cleaning is convenient. It is suitable for all kinds of prefabricated parts factories and industrial and civil construction projects of highways, bridges, water conservancy, docks.
